The staggered pull.
Ada door pull height.
Click here for printable pdf version.
You should always check.
1220 mm above finished floor.
Obstructions at side reaches are limited to a height of 34.
Door handles pulls latches locks and other operating devices shall be installed 34 inches 864 mm minimum and 48 inches 1219 mm maximum above the finished floor.
Door hardware ada compliant locks exit devices handles pulls latches and other operable parts on doors shall comply operable parts of such hardware shall be 34 inches minimum and 48 inches maximum above the finish floor or ground.
Ada door handle height requirement.
Access doors or gates in.
About staggered pulls levers and ada design.
Front approaches to pull side of swinging doors shall have maneuvering space that extends from the hinge side of the door to 18 inches 455 mm minimum 24 inches 610 mm preferred beyond the latch side of the door and 60 inches 1525 mm minimum perpendicular to the doorway.
Therefore when the handle ladder pull is installed there must be a clear distance from the glass surface to the inside of the pull surface of 2 1 2 or 64 5mm.
Pre existing locks most likely not applicable to new builds gates protecting pools spas and hot tubs are allowed to be a bit higher up to 54.
This facilitates access since mobility aids including wheelchair footrests are sometimes used to push or prop open doors.
Door hardware mounting heights 2010 ada changes ibc 2009.
This provides a clearance of 10 inches or more from the finished floor required by code.
A few exceptions are included in the bill.
Is designed to have full height inside the office while offering shortened height outside the office door corridor.
Door and gate surfaces 404 2 10 the bottom surface of doors and gates on the push side must be smooth to a height of at least 10.
The height of the door handle must be between a minimum of 34 and a maximum of 48.
The maximum high reach is reduced to 46 when the reach over an obstruction is deeper than 10 to a maximum of 24.
Recommended locations on door.
Door handles pulls latches locks and other operating devices shall be installed 34 inches 864 mm minimum and 48 inches 1219 mm maximum above the finished floor.
Pull positioning on plates wider than 4 handing required.
Door pulls do not always have to lock into header ceiling.
Hardware required for accessible door passage shall be mounted no higher than 48 in.
