You can use an existing power source but if that is not an option then use a switch controlled.
Add canned lights to ceiling on first floor.
Position the clips off center by about 7 inches then cut enough wire to run between each clip and the main ceiling grid plus 24 inches of extra wire to complete a securing wrap at each attach point.
Locate an available branch circuit to use as a power source.
It is easier to tap into an existing circuit via a receptacle than to run.
Cut a hole into the ceiling with a drywall saw.
Use chalk lines to ensure that the.
Place an old work electrical.
Cut the hole with a drill with a hole cutting attachment and mark all light locations.
Then press the can up until it s flush with your ceiling.
How to install recessed lighting without access to the attic.
When installing recessed lighting in an existing ceiling a hole is cut in the ceiling that exactly fits the profile of a special remodeling can to keep from damaging the surrounding drywall.
Then press the four tabs through the light fixture until they sit flush against the can.
Make sure the tabs lock into place.
Hold the recessed light housing up to the ceiling in the desired installation location.
Make sure you do not snag any wires that may be in the ceiling cavity.
Turn off the power to the room at the main circuit breaker.
Mark the locations of the recessed lights on the ceiling.
6 feed the junction box and the arm of the light fixture into the ceiling hole.
How to install recessed lighting between floors.
Reach through the recessed light holes to drill through joists that aren t accessible from the slot in the ceiling.
To make sure you get the installation right the first time around draw up a.
Cutting a hole in your.
Test to see if the power is off by inserting a circuit tester plug into an.
Cut slot in ceiling and fish cable.
Install four suspension clips two on each side to the floor joists above the ceiling tile.